[William]

I purchased your FL Studio template which is all one needs. However, I decided to switch to a 3rd party VST3 (picked so I can do automation as you suggested in the Basic course), but I couldn’t figure out how to edit it. Haha Also, I enjoy your well-written responses. This is something basic I have skipped over. 😛

[GratuiTous]

Hey William, thanks for grabbing my FL Studio Template!

I’m not sure what your direct question is here!

Note – you do not need VST3 to create automation clips.  What I mentioned was that sometimes VST3 allows you to RIGHT-CLICK and create an automation clip from a knob as if it were a NATIVE FL STUDIO PLUGIN.

The automation clip gets added to the Playlist, then you are able to add and remove new automation points with RIGHT-CLICK, then adjust them with LEFT-CLICK + HOLD.

(If you right-click a point, you are then presented with even more automation curve options!)

For more info:

• Watch my Automation Clips Course!
• Listen to my Podcast on Automation Clips

[William]

I will check out your course content for clarification. I asked this question too quickly, but it did raise an interesting point about automation. Cool.

[GratuiTous]

No problem!  This questions area is meant to be used for everyone to learn, so when you have serious questions, feel free to leave a question and I’ll respond when I can!

Closing this one, thanks again for your enrolment to the membership 🙂